Charging Your Headset

Charging Your Headset

To charge your OV Pro headphones plug the provided USB cable into the headphones port by opening the cover on the right side bottom and plugging in the USB cable. Plug the other end into a USB charging device such as your laptop, car adapter, or other USB port. The light on the headphones will turn red when charging and green when charged. The light is near the USB port on the headphones. OV Pro utilizes a USB-C charging port.

You can use your headphones while it is charging however you are limited by the cord length.

When there is a low battery, the headphones will play a prompt “low battery” about every 30 seconds.











If the headset does not charge
  1. Allow up to four hours to fully charge the battery
  2. A full charge powers the headphones for up to 14 hours
  3. Make sure the USB connector on the cable is correctly aligned with the USB connector on the headphones
    1. Disconnect the USB charging cable on both ends and reconnect
  4. If your headphones have been exposed to high or low temperatures, let the headphones return to room temperature and then try charging again
  5. Try using a different power source to charge the headphones
  6. Before charging, be sure the headphones are at room temperature, between 41° F (5° C) and 104° F (40° C)


    • Related Articles

    • More Headset Tips

      How is your OV Pro treating you?  Have you expanded its features by connecting the OV Loop App?  Here are a few other things you can try with OV Pro!  Wake Words!  We have voice-powered OV Pro.  Simply say “OV Phone” to access Siri or Google Voice.  ...

    • Quick Tip on Getting Started

      Thank you for purchasing OV Pro!  We are excited for you to experience the next generation headset!  We have a few tips when you open the box! Power On/Off  Press and hold the Play/Power button.  A single vibration indicates it’s on.  Two vibration ...

    • How to Perform a Master Reset

      To perform a master reset of the OV Exec headset perform the following: Turn the headset on Hold down the 2 center buttons - one on each arm for approximately 5 seconds The left will be the DOWN Arrow The right will be the "-" Minus button The light ...

    • Clearing the OV Pro Bluetooth Pairing List

      To clear the OV Pro headphones paired list: Power the headset on Hold the Left and Right Collar (Big) buttons for 5 seconds until the headset vibrates Note: Re-pair the headphones to the device you want to use.

    • Firmware Update

      Firmware on the headset is updated through the OV Loop Application for either Android or iOS. The application version will change if a new update is available.  As of this article the latest Android is version 2.2.91.0 and the latest iOS is 2.1.0 ...